FSP300-60GLS - 300 Watt Micro ATX Power Supply

Product Number FSP300-60GLS

The FSP300-60GLS power supply has been replaced by
FSP300-60GHS,
which is a more efficient, more powerful, and 100% compatible power supply.

FSP300-60GLS Replaces the following computer power supplies:

Astec ATX202-3515-1412B

Astec ATX202-3545

Astec ATX202-3515

Delta DPS-300AB-9

FSP FSP270-50SNV

FSP FSP300-60GLS

FSP FSP200-50SNV

FSP FSP300-62GLS

FSP FSP300-60GLS-MJR

FSP 9PA2700126

FSP FSP300-60GNV

Gateway 6500308

Gateway 6500400

Gateway Performance 500

Gateway 2000 G6-233

Gateway Performance 750

Gateway 6500184

HP Pavilion 531W

Newton 79F3391

Newton NPS-200PB-56C

Newton NPS-200PB-96D

PowerMan FSP270-50SNV

PowerMan FSP300-60GLS

PowerMan FSP300-60GNV

Sparkle FSP270-50SNV

Sparkle FSP300-60GLS

Sparkle FSP200-50SNV

Sparkle FSP300-60GLS-MJR

Sparkle 9PA2700126

Sparkle FSP300-60GNV

   

Key Features:

1. High efficiency
2. Low ripple & noise
3. Output over voltage protection
4. Short circuit protection on all outputs
5. Resettable power shut down
6. Internal 8 cm fan
7. 100% burn-in under high ambient temperature (50°C)
8. MTBF: 100K hours at 25°C
9. Active PFC (Power Factor Correction) circuit

Product Description:

If you're looking for a micro atx power supply that sports just as much power as the full blow atx power supplies then here it is. The FSP300-60GLS delivers the punch that many of your are looking for. Use this power supply for when you upgrade your video cards or any other thing that requires that you increase the capacity of your micro atx power supply.

Technical Specs:

• 5" Wide X 2.5" Tall X 4" Deep
• One ATX 2.03 connector (20/24 pin)
• One 12V connector for P4 motherboards
• Three IDE 4 PIN connectors
• One Floppy 4 PIN connector
• Two SATA connectors
• Voltage: Full Range Input
• Frequency: 47Hz - 63Hz.
• Input current: 4.0 amps maximum / 115 Vrms; 2.0 amps maximum / 230 Vrms.
• Over-voltage protection: +12V : 15.6V(maximum); +5V : 7.0V (maximum); +3.3V : 4.8V (maximum)
• Over-current protection: +3.3V : 45A maximum; +5V : 45A maximum; +12V1 DC : 22A maximum; +12V2 DC : 22A maximum.
• Remote ON/OFF control: The power supply shall accept a logic collector level which will disable / enable all output voltage (excluding +5V standby).
• Power good signal: 115/230V (full load) : 100 - 500 ms
• Efficiency: 75% / 115V; 78% / 230V.
• Hold-up time: 17.0 ms minimum: at 115V / 60 Hz; 17.0 ms minimum: at 230V / 50 Hz.
• Operating conditions: ambient temperature 0°C~+50°C
• Storage and shipping conditions: ambient temperature -20°C~+80°C
• Dielectric withstand: input / output 1800 VAC for 1 second, input to frame ground 1800VAC for 1 second