| |
FSP350-60THN - 350 Watt ATX Power Supply
Product Number FSP350-60THN
$44.99
Having trouble making a selection? See our article on Choosing a Power Supply.
FSP350-60THN
Replaces the following computer power supplies: | FSP FSP350-60THN
Gateway 614GE
Gateway 3200S
PowerMan FSP350-60THN
Sparkle FSP350-60THN
 | | | | | |
|
Key Features:
- Common replacement power supply for Gateway and other popular brands. See our list below.
- Low ripple & noise
- Output over voltage protection
- Short circuit protection on all outputs
- Safety approved: UL, CSA, TUV, NEMKO, BSMI, FCC, CB
- 100% burn-in under high ambient temperature (50°C)
- Vacuum-impregnated transformer
- MTBF: 100K hours at 25°C
- 100% Hi-pot tested
- Line input fuse protection
- With 120mm big fan
Product Description:
This FSP350-60THN 350 watt atx computer power supply is a suitable replacement for Gateway and several major brands of power supplies. Enjoy long trouble free life from this power supply because FSP is among the lowest in returned merchandise in the industry.
Easily converts from 20 to 24 pin atx connector to adapt to your application... an excellent 20 pin to 24 pin atx connector adapter.
Looking to upgrade? Try this power supply. It's 630 watts and provides needed power when upgrading video cards or adding devices to your computer.
Technical Specs:
- ATX Form factor
- 6.00" Wide X 3.25" Tall X 5.75" Deep
- One ATX 2.03 connector (20 pin or 24 pin)
- One 12V connector for P4 motherboards
- Four IDE 4 PIN connectors
- One Floppy 4 PIN connector
- Two SATA connectors
- Voltage:
115 / 220-240 VAC
- Frequency: 47 Hz to 63 Hz
- Inrush current: 90amps cold, 120 amps warm, measured at 264 Vrms
- Input current: 7 amps maximum / 115 Vrms, 60 Hz.
3.5 amps maximum / 230 Vrms, 50 Hz
- Over-voltage protection: +3.3V, +5V,+12V1, 12V2
- Over-current protection: +3.3V, +5V,+12V1, 12V2
- Short circuit protection: The power supply is prevented from output over current.
- Remote ON/OFF control: The power supply shall accept a logic open collector level which
will disable / enable all output voltage (excluding +5V standby)
- Power good signal: 115/230V (full load) 100-500 ms
- MTBF:
100K hours at 25°C
- Efficiency: 70% min.
- Hold-up time: 17.0 ms minimum: at 115V / 60 Hz.
17.0 ms minimum: at 230V / 50 Hz.
- Operating conditions:
ambient temperature 0°C~50°C, 90% RH
- Storage and
shipping conditions: ambient temperature -20°C~65°C, 95% RH
- Dielectric strength: primary to frame ground 1800 VAC for 1 second,
primary to secondary 1800 VAC for 1 second
| Output |
Min. Load |
Max. Load |
Load Reg. |
Ripple & Noise |
| +3.3V |
0.5A |
22A |
±5% |
50mV P-P |
| +5V |
1.0A |
21A |
±5% |
50mV P-P |
| +12V1DC |
1.0A |
10.0A |
±5% |
120mV P-P |
| +12V2DC |
1.0A |
15.0A |
±5% |
120mV P-P |
| -12V |
0A |
0.3A |
±10% |
120mV P-P |
| +5Vsb |
0A |
2.0A |
±5% |
50mV P-P |
|
