atx power supplies Power Supply Universal Laptop Power Adapter
Power Supplies - ATX Contact ATXPowerSupplies.com Order Status Checkout Power Supply Cross Reference Laptop Power Supply Cross Reference

 

FSP180-50NIV-H - 180 Watt SFX Power Supply for HP, Compaq, Emachine and others.

Product Number FSP180-50NIV-H

fsp180-50niv-h 180 watt sfx computer power supply

This power supply has been discontinued and replaced with the MP4ATX30.

 

Key Features:

  1. Common replacement power supply for HP, Compaq, Emachine and other popular brands. See our list below.
  2. High efficiency
  3. Low ripple & noise
  4. Output over voltage protection
  5. Short circuit protection on all outputs
  6. Resettable power shut down
  7. Internal 8 cm fan
  8. 100% burn-in under high ambient temperature (50°C)
  9. MTBF: 100K hours at 25°C
  10. Passive PFC (Power Factor Correction) optional
  11. Approve by UL, CAS, TUV, NEMKO, BSMI, FCC, CB

Product Description:

The FSP180-50NIV-H is a common replacement power supply for dozens of different models of HP, Compaq, Emachine, and other brand computers. Chances are if you landed on this page looking for this computer power supply you're in luck. See are list below of popular computer models this power supply replaces.

Your old power supply might have a 3 wire connector that goes to the motherboard from your power supply. This new power supply has its own internal fan control, and does not require the 3 wire connector like your old power supply does.

Looking to upgrade? Check and see if you need the 4 wire video connector that this power supply has? If not then you can probably upgrade to this 300 Watt Micro ATX Power Supply.

Technical Specs:

  • SFX Form factor
  • 5" Wide X 2.5" Tall X 4" Deep
  • One ATX 2.03 connector (20 pin)
  • One 12V connector for P4 motherboards
  • Three IDE 4 PIN connectors
  • One Floppy 4 PIN connector
  • One Video Power connector
  • Voltage: 115/230 VAC
  • Frequency: 47Hz - 63Hz
  • Input current: 6.0 amps maximum / 115 Vrms, 60Hz; 3.0 amps maximum / 230 Vrms, 50Hz.
  • Over-voltage protection: +5V: 6.5V (maximum); +3.3V: 4.6V (maximum); +12V:15.5V (maximum)
  • Over-current protection: +3.3V:55A maximum; +5V:42A maximum; +12V:20A maximum
  • Remote ON/OFF control: The power supply shall accept a logic collector level which will disable / enable all output voltage (excluding +5V standby).
  • Power good signal: 115/230V (full load): 100 - 500 ms
  • Efficiency: 65% min.
  • Hold-up time: 16.6 ms minimum: at 115V / 60 Hz; 16.6 ms minimum: at 230V / 50 Hz.
  • Operating conditions: ambient temperature 0C~50C
  • Storage and shipping conditions: ambient temperature -20C~+65C
  • Dielectric withstand: input / output 1800 VAC for 1 second, input to frame ground 1800VAC for 1 second
Output Min. Load Max. Load Load Reg. Ripple & Noise
+5Vsb 0A 2A ±5% 50mV P-P
-12V 0A 0.3A ±10% 120mV P-P
+12V 2.0A 10A ±5% 120mV P-P
+5V 1.0A 16/12.6A ±5% 50mV P-P
+3.3V 0.5A 11.5/16.7A ±5% 50mV P-P
-5V 0A 0.2A ±10% 120mV P-P

Copyright © 2018 ATXPowerSupplies.com
142 Jodie Williams Road, Suite ATXPS
DeRidder, LA 70634
Phone: 800-458-1606