atx power supplies Power Supply Universal Laptop Power Adapter
Power Supplies - ATX Contact Order Status Checkout Power Supply Cross Reference Laptop Power Supply Cross Reference


FSP400-60THN - 400 Watt ATX Power Supply

Product Number FSP400-60THN



The power supply comes with the connectors shown. If you need additional connectors you may add from the list below:
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image
view image is safe to buy from.

Replaces the following computer power supplies:

Key Features:

  1. Common replacement power supply for Gateway and other popular brands. See our list below.
  2. Low ripple & noise
  3. Output over voltage protection
  4. Short circuit protection on all outputs
  5. Safety approved: UL, CSA, TUV, NEMKO, BSMI, FCC, CB
  6. 100% burn-in under high ambient temperature (50°C)
  7. Vacuum-impregnated transformer
  8. MTBF: 100K hours at 25°C
  9. 100% Hi-pot tested
  10. Line input fuse protection
  11. With 120mm big fan

Product Description:

This FSP400-60THN 400 watt atx computer power supply is a suitable replacement for Gateway and several major brands of power supplies. Enjoy long trouble free life from this power supply because FSP is among the lowest in returned merchandise in the industry.

Looking to upgrade? Try this power supply. It's 630 watts and provides needed power when upgrading video cards or adding devices to your computer.

Technical Specs:

  • ATX Form factor
  • 6.00" Wide X 3.25" Tall X 5.75" Deep
  • One ATX 2.03 connector (20/24 pin)
  • One 12V connector for P4 motherboards
  • Four IDE 4 PIN connectors
  • One Floppy 4 PIN connector
  • Two SATA connectors
  • Voltage: 115 / 220-240 VAC
  • Frequency: 47 Hz to 63 Hz
  • Inrush current: 90amps cold, 120 amps warm, measured at 264 Vrms
  • Input current: 7 amps maximum / 115 Vrms, 60 Hz. 3.5 amps maximum / 230 Vrms, 50 Hz
  • Over-voltage protection: +3.3V, +5V,+12V1, 12V2
  • Over-current protection: +3.3V, +5V,+12V1, 12V2
  • Short circuit protection: The power supply is prevented from output over current.
  • Remote ON/OFF control: The power supply shall accept a logic open collector level which will disable / enable all output voltage (excluding +5V standby)
  • Power good signal: 115/230V (full load) 100-500 ms
  • MTBF: 100K hours at 25C
  • Efficiency: 70% min.
  • Hold-up time: 17.0 ms minimum: at 115V / 60 Hz. 17.0 ms minimum: at 230V / 50 Hz.
  • Operating conditions: ambient temperature 0C~50C, 90% RH
  • Storage and shipping conditions: ambient temperature -20C~65C, 95% RH
  • Dielectric strength: primary to frame ground 1800 VAC for 1 second, primary to secondary 1800 VAC for 1 second
Output Min. Load Max. Load Load Reg. Ripple & Noise
+3.3V 0.5A 30A ±5% 50mV P-P
+5V 1.0A 28A ±5% 50mV P-P
+12V1DC 1.0A 14A ±5% 120mV P-P
+12V2DC 1.0A 15.0A ±5% 120mV P-P
-12V 0A 0.5A ±10% 120mV P-P
+5Vsb 0A 2.0A ±5% 50mV P-P

Copyright © 2018
142 Jodie Williams Road, Suite ATXPS
DeRidder, LA 70634
Phone: 800-458-1606