NPS-200PB-121 B and NPS-200PB-121 A Power Supply Replacement

Product Number NPS200

Click to enlarge

See the Video of the NPS200

$99.99

No Power Cord +$ 0.00 Power Cord +$1.00 view image
No Y-Splitter +$ 0.00 Y-Splitter +$4.00 view image
No PCI Express Adapter +$ 0.00 Molex to PCI Express Adapter +$6.00 view image
No Zip Ties +$ 0.00 Lot of 10 Zip Ties +$2.00 view image
No 20 to 24 pin atx adapter +$ 0.00 20 to 24 pin atx adapter +$6.00 view image
No 20 pin atx extension +$ 0.00 20 pin atx extension +$5.00 view image
No 20 pin atx splitter +$ 0.00 20 pin atx splitter +$14.99 view image
No 24 to 20 pin atx adapter +$ 0.00 24 to 20 pin atx adapter +$6.00 view image
No Molex to SATA adapter +$ 0.00 Molex to SATA adapter +$6.00 view image
No SATA to Molex adapter +$ 0.00 SATA to Molex +$6.00 view image
No 6 Pin AUX adapter +$ 0.00 6 Pin AUX adapter +$15.99 view image
No Sata Y Splitter +$ 0.00 Sata Y Splitter +$6.00 view image
No Molex to P4 Converter +$ 0.00 Molex to P4 Converter +$6.00 view image
No P4 Extension +$ 0.00 P4 Extension +$5.00 view image
No Power Supply Tester +$ 0.00 Power Supply Tester +$9.99 view image
No LCD Power Supply Tester +$ 0.00 LCD Power Supply Tester +$14.99 view image

NPS200 Replaces the following computer power supplies:

Newton NPS-200PB-121 B

Newton NPS-200PB-121 A

Key Features:

• Design to replace Newton NPS-200PB-121 A and NPS-200PB-121 B power supplies
• 240 watts - more power than your original power supply

Product Description:

This power supply was designed to replace the NPS-200PB-121 B. You should pay close attention to whether or not the P8 connector is needed. If your original NPS-200PB-121 A or NPS-200PB-121 B has the P8 connector shown below and it is actually in use on your computer then you are going to need to use the included wire taps. The wire taps should be used to tap into the 12V power on the P4 connector on the new power supply. If you need the P8 connector for your application then you must cut off the P8 connector on your old power supply. Use one wire tap and connect the yellow wire on your P8 connector to a yellow wire on the P4 connector on this power supply. Use the other wire tap to connect the black wire on your P8 connector to a black wire on the P4 connector on this power supply. Open the video below the picture of the power supply to see a demonstration of tapping your old P8 connector into the P4 connector on this power supply. If you do not need the P8 connector then this power supply will bolt right into place on your system without modification.

Technical Specs:

• 5" Wide X 3.375" Tall X 7.5 " Deep
• One ATX connector (20/24 pin)
• One P4 connector
• One SATA connector
• Three Molex connectors
• One floppy connector